2218 Bearing
Self-aligning ball bearing
- Bore d90 mm
- Outer dia. D160 mm
- Width B40 mm
- Weight≈ 3.1 kg
Light to medium loads with shaft deflection or misalignment.
Technical data
| Bearing designation | 2218 |
|---|---|
| Type | Self-aligning ball bearing |
| Bore d | 90 mm |
| Outer dia. D | 160 mm |
| Width B | 40 mm |
| Weight | ≈ 3.1 kg |
Dimensions are standard catalogue values; the weight is an approximate calculation. Please confirm before ordering.
Common suffixes for 2218
| 2218 K | Tapered bore, taper 1:12 |
|---|---|
| 2218 ETN9 | Reinforced internal design (higher load capacity) · Glass-fibre reinforced polyamide cage |
| 2218 C3 | Radial clearance larger than normal (for higher operating temperatures) |
| 2218 K C3 | Tapered bore, taper 1:12 · Radial clearance larger than normal (for higher operating temperatures) |
| 2218-2RS | Rubber seals on both sides (sealed), greased |
Click a designation to open it in the bearing finder. Suffix usage can differ slightly between brands.
Matching seal (radial shaft seal)
90 × 160 × 12 mm
Seal weight: ≈ 0.18 kg
Other common widths: 90 × 160 × 10 mm, 90 × 160 × 15 mm
The seal's inner diameter matches the shaft (90 mm) and its outer diameter matches the housing bore (160 mm); the width depends on the space in the housing. NBR (double lip, TC type) is recommended for general use and FKM (Viton) for high temperatures.
Quote for bearing and sealAll seal sizes and matching bearings →
Matching sleeve
H 318 · shaft 80 mm
Adapter sleeve H 318: shaft diameter 80 mm, bearing bore 90 mm, width 65 mm. Used with lock nut KM18 and lock washer MB18.
H 318 set weight (incl. lock nut and lock washer): ≈ 1.3 kg
A sleeve mounts a tapered-bore bearing on a plain cylindrical shaft and bridges the difference between the bearing bore and the shaft diameter.
Use with a sleeve requires the tapered-bore version of the bearing: 2218 K.
Quote for bearing and sleeve